---

2.3 Power Control

Not available for Lite.

SZ[!] ¶

Show the on/off power state of the connected SBC. If the power monitoring option has been purchased then also show the voltage supplied to the device and the current it is drawing. Appending the ! to the command monitors the power supply in a continuous loop until Carriage Return (CR) is pressed.

DZ[0|1|W] ¶

Turn the power supply of the SBC off (0) or on (1). Switch the terminal server off (W) until receipt of a Wake-on-LAN magic packet over Ethernet.

DZ[I|L] ¶

Define the behavior of the terminal server when it is switched on in response to a Wake-on-LAN magic packet. Ignore or leave as-is (I), or always switch on (L).